C16450
Universal Asynchronous Receiver/Transmitter

Function Description

The C16450 programmable asynchronous communications interface (UART) core provides data formatting and control to a serial communication channel.

The core has select, read/write, interrupt and bus interface logic features that allow data transfers over an 8-bit bi-directional parallel data bus system. With proper formatting and error checking, the core can transmit and receive serial data, supporting asynchronous operation.

Features

• Full double buffering
• Asynchronous operation
• Independently controlled Transmit, Line Status, Receive, and Data Set Interrupts
• Programmable data word length (5 - 8 bit), parity and stop bits
• Parity, overrun and framing error checking
• Supports up to 1.5 Mbps transmission rates
• Programmable Baud Rate Generator allows division of any reference clock by 1 to (2¹⁶-1) and generates an internal 16 X Clock
• False start bit detection
• Automatic break generation and detection
• Internal diagnostic capabilities
• Peripheral modem control functions
• The C16450 was developed in VHDL and synthesizes to approximately 2,000 gates depending on the process used

 

Symbol

 

Pin Description

Name	Type	Polarity	Description
RESET	In	High	External Rest
CLK	In	-	Master Clock
RCLK	In	-	Receive Clock
ADSn	In	Low	Address Strobe
RDn	In	Low	Read Control
WRn	In	Low	Write Control
CS0	In	High	Chip Select 0
CS1	In	High	Chip Select 1
CS2n	In	Low	Chip Select2
DIN[7:0]	In	-	Data Input Bus
CTSn	In	Low	Clear-to-Send
DSRn	In	Low	Data Set Ready
DCDn	In	Low	Data Carrier Detect
RXDATA	In	-	Receive Data
RIn	In	Low	Ring Indicator
A[2:0]	In	-	Register Select
D0[7:0]	Out	-	Data Output Bus
TXDATA	Out	-	Transmit Data
DDIS	Out	High	Driver Disable
RTSn	Out	Low	Request-to-Send
DTRn	Out	Low	Data Terminal Ready
OUT1n	Out	Low	Output 1
OUT1n	Out	Low	Output 2
CSOUT	Out	High	Chip Select Out
INTRPT	Out	High	Interrupt
BOUDOUTn	Out	Low	Baud Out

 

Block Diagram

Please send your comments to webmaster@moxsyn.com